What does your Deako system need to get firmware updates? WiFi, of course! Check out the steps below to make sure you're good to go.
Before you begin...
1. Go to WiFi Settings
Open the Deako app and navigate to Settings > WiFi Settings
2. Check your WiFi Settings
✖ If the status shows as disconnected ...
Power cycle the device listed in the device field. Close the Deako App and wait a few minutes. Then open the app again and check the WiFi settings. If it still shows disconnected, follow the instructions in the red alert.
✔ If the device field says something else ...
You are good to go! Your WiFi is set up and connected.
3. Reconfigure your WiFi settings
Hit Reconfigure.
4. Select your Device
You should see the names of your Smart Switches listed, select one of them.
5. Follow the in-app instructions
Complete the WiFi setup by following the in-app instructions.